|
Uses RJ-45 straight-through cable from router to wall
(supplied)
Has red tag labeled "TPE Straight".
(user may have cable with blue tag labeled
"ISDN or ADSL")
Uses RJ-45 crossover cable from router to computer
(supplied)
Has yellow tag labeled "TPE Crossover"
Uses RJ-45 cable for console control (supplied but not
required)
Has green tag labeled "Console"
|
|
|
|
1 PWR
2 TEST
3 LINK (sync)
4 WAN
5 LANT
6 LANR
|
|
|
On/Off switch
Power connector (computer style cord)
ADSL R-CAP port (Red RJ-45 cable to wall jack)
Set of 6 dip switches - normal operation is first 4 down
and last 2 up Note: The first 4 are not used for
anything, only 5 & 6 actually function 10BASE-T port
(Yellow RJ-45 cable to computer)
CONSOLE port (RJ-45 cable to computer to telnet into
router)
|
|
|
| Status |
POWER
|
TEST
|
LINK
|
WAN
|
LANT
|
LANR
|
| Off |
Power not applied
|
Power not applied
|
Dip switches
mis-configured
|
No DSL traffic
|
Normal
|
Normal
|
| Green |
Normal
|
Normal
|
Normal
|
N/A
|
Normal
|
Normal
|
| Blinking
Green |
N/A
|
N/A
|
No Sync
|
DSL traffic
is flowing
|
Ethernet Transmitting
|
Ethernet Receiving
|
| Amber |
N/A
|
Hardware error
|
N/A
|
N/A
|
N/A
|
N/A
|
When first
powered on, the first four LED's blink as the hardware initializes.
Normal operation after power up: First three lights solid green.
|
|
| NIC IP: 192.168.254.1 |
Subnet Mask: 255.255.255.0
|
Modem IP: 192.168.254.254
|
It is not necessary to specify IP's in the TCP/IP
settings unless you need to ping the NIC and/or router, or the
user is receiving TAP errors. If you do specify the IP, you
should use the above settings for this modem. Windows:
Enter these settings in the TCP/IP properties of the Ethernet
Adapter connected to the DSL modem. The TCP/IP settings for both
the NIC and the NTS PPPoE Adapter are normally set the same way
we set up TCP/IP for the Dial-up Adapter:
• Obtain an IP address automatically
• Disable WINS resolution
• Installed gateways is blank
• Disable DNS
Mac:
Change TCP/IP from "Connect via Enternet" to
"Connect via Ethernet" and change "Configure
Using PPP Server" to "Configure Manually". Enter
the appropriate IP and Subnet Mask, then close and save the
changes. Run the OT Tool directly from the MindSpring CD.
(located in the Other Software or Software Depot folder) In the
lower right corner, enter the NIC or router's IP address and
click on the "Ping" button. See
Picture
Flowpoint
2100 Manual (1Mb)
|
|
