SpeedStream 5260 Ethernet Based Modem/Bridge

Uses standard RJ-11 phone cord between modem and wall jack (supplied)
Uses RJ-45 straight-through cable between modem and computer (supplied)  (Cable is gray in color)
Uses RJ-45 crossover cable to connect the modem to a hub (supplied)
 (Cable is white and may be marked "XOVER")
  

Front Panel LED's
1 SYS (power)
2 ATM
3 DSL (sync)
4 ENET
  
 
Rear Panel Connections
On/Off button
DSL port (RJ-11 cable to wall)
Ethernet port (RJ-45 cable to computer)
Power connector (detachable AC adapter)
  

LED Troubleshooter
Status
SYS
ATM
DSL
ENET
Off
Power not applied
Power not applied
No Sync
No Ethernet detected
Green
Operational
Internet carrier detected
DSL line is
trained and ready
Ethernet detected
Blinking Green
N/A
Internet traffic is flowing
N/A
Ethernet traffic
Yellow
Router problem
N/A
N/A
N/A
Blinking Yellow
N/A
N/A
Training
Ethernet collisions
Red
N/A
N/A
DSL line error
Ethernet line error
When first powered on, all four LED's are red as the hardware initalizes.
Normal operation after power up: All four lights solid green.
  

Network Settings
 NIC IP:  10.0.0.2
Subnet Mask:  255.0.0.0
Modem IP:  10.0.0.1 

It is not necessary to specify IP's in the TCP/IP settings unless you need to ping the NIC and/or router, or the user is receiving TAP errors. If you do specify the IP, you should use the above settings for this modem. Windows:
Enter these settings in the TCP/IP properties of the Ethernet Adapter connected to the DSL modem. The TCP/IP settings for both the NIC and the NTS PPPoE Adapter are normally set the same way we set up TCP/IP for the Dial-up Adapter:
  • Obtain an IP address automatically
  • Disable WINS resolution
  • Installed gateways is blank
  • Disable DNS
Mac:
Change TCP/IP from "Connect via Enternet" to "Connect via Ethernet" and change "Configure Using PPP Server" to "Configure Manually". Enter the appropriate IP and Subnet Mask, then close and save the changes. Run the OT Tool directly from the MindSpring CD. (located in the Other Software or Software Depot folder) In the lower right corner, enter the NIC or router's IP address and click on the "Ping" button. See Picture



 Speedstream 5260 Manual (80k)