SpeedStream 5660 Ethernet Based Router/Bridge

Uses standard RJ-11 phone cord between router and wall jack (supplied)
Uses RJ-45 straight-through cable between router and computer (supplied)  (Cable is gray in color)
Uses RJ-45 crossover cable to connect the router to a hub (supplied)
 (Cable is white and may be marked "XOVER")
Uses RS-232 cable for console control (supplied but not required)
  


Front Panel LED's
1 SYS (power)
2 ATM
3 DSL (sync)
4 ENET

  
 
Rear Panel Connections
On/Off button
DSL port (RJ-11 cable to wall)
Ethernet port (RJ-45 cable to computer)
Serial port (optional)
Power connector (detachable AC adapter)
  

LED Troubleshooter
Status
SYS
ATM
DSL
ENET
Off
Power not applied
DSL line is not trained
N/A
No link detected
Green
Operational
ATM cell delineation
DSL line is
trained and ready
Ethernet detected
Blinking Green
N/A
ATM cell delineation
and traffic flow
The DSL line
is being trained
Carrier detected and traffic is flowing
Yellow
POST Phase
N/A
N/A
Carrier not detected
Blinking Yellow
POST Failure
N/A
N/A
Ethernet collisions
Blinking Green
and Yellow
N/A
N/A
No Sync
N/A
Red
N/A
N/A
DSL line error
N/A
When first powered on, all four LED's are red as the hardware initializes.
Normal operation after power up: All four lights solid green.
  

Network Settings
 NIC IP:  10.0.0.2
Subnet Mask:  255.0.0.0
Modem IP:  10.0.0.1 

It is not necessary to specify IP's in the TCP/IP settings unless you need to ping the NIC and/or router, or the user is receiving TAP errors. If you do specify the IP, you should use the above settings for this modem. Windows:
Enter these settings in the TCP/IP properties of the Ethernet Adapter connected to the DSL modem. The TCP/IP settings for both the NIC and the NTS PPPoE Adapter are normally set the same way we set up TCP/IP for the Dial-up Adapter:
  • Obtain an IP address automatically
  • Disable WINS resolution
  • Installed gateways is blank
  • Disable DNS
Mac:
Change TCP/IP from "Connect via Enternet" to "Connect via Ethernet" and change "Configure Using PPP Server" to "Configure Manually". Enter the appropriate IP and Subnet Mask, then close and save the changes. Run the OT Tool directly from the MindSpring CD. (located in the Other Software or Software Depot folder) In the lower right corner, enter the NIC or router's IP address and click on the "Ping" button. See Picture


 Speedstream 5660 Manual (34k)